Before you start
Mold needs water, so it grows wherever water leaks, condenses or sits. Start with these six spots, which are easy to check and easy to miss, then work through the rest of the house.
Bring a bright flashlight, a small mirror or your phone’s camera, and a humidity meter ($10 to $50 at hardware stores). EPA advises keeping indoor humidity below 60%, ideally 30 to 50% (EPA). Wear an N95 mask and gloves if you’ll be lifting carpet or going into the attic or crawl space.
Signs to look for:
- Spots or fuzz of any color: black, green, gray, white or blue.
- Water stains, peeling or bubbling paint, and drywall or wood that’s soft, warped or swollen.
- Condensation on windows, walls or pipes, and rust on metal.
- A musty, earthy smell, especially when you open a cabinet or closet or the air conditioning comes on.
Pink or orange slime in toilets, tubs and drains is usually bacteria rather than mold. It grows in the same wet spots, so note it too.
Tick each spot as you go. Your checks are saved on this device.
1. Under sinks
Check the kitchen sink and every bathroom sink. Open the cabinet and smell before you look: a musty smell in a closed cabinet is often the first sign.
2. Under toilet rims
Water runs through the rim and out of small holes on its underside, so they stay wet and are hard to see. Use a flashlight with a small mirror or your phone’s camera, and check every toilet.
3. Inside toilet tanks
Lift the lid off and set it down on a towel: it’s heavy and breaks easily.
4. Behind registers
Take the covers off a few vents, including any in the bathroom and kitchen and any on the ceiling, and shine a light into the duct. Where cold air from the AC meets humid air, water condenses on and around the vent.
5. Inside the washing machine
Front-loaders are the worst for this, because water sits in the rubber door seal after every wash. A musty smell from the drum or on clean laundry is a sign.
6. Behind shower curtains
Pull the curtain and liner flat and look at both sides, then at the tub and wall behind them.
More places to check
These are the other common spots, room by room.
Kitchen
Bathrooms
Heating and cooling
Windows and walls
Laundry and utility
Basement and crawl space
Attic
Anywhere
If you find mold
- Fix the water first. If you clean up mold but don’t fix the leak or damp, it will most likely come back.
- Small patches on hard surfaces, like tile, tubs, toilets and metal: scrub with detergent and water, then dry completely. Wear an N95, gloves and goggles.
- Porous things that grew mold, like drywall, ceiling tiles, carpet and cardboard, may have to be thrown out, because mold fills the spaces inside them.
- Don’t paint or caulk over it. Clean and dry it first, or the paint will likely peel.
- Don’t run the heating or AC if you think there’s mold in the system, because it can spread it through the house.
- Call a professional for patches bigger than about 10 square feet (roughly 3 feet by 3 feet), mold inside walls or ducts, or damage from sewage or floodwater.
- If mold affects your health, have someone else do the cleanup.
These steps follow EPA’s Brief Guide to Mold, Moisture and Your Home.